The new, easy-to-use Malem wireless bedwetting alarm system makes it simple to be alerted when wetting occurs. At bedtime, your child attaches the Easy-Clip sensor to the outside of his or her close-fitting underwear. This sensor is connected to the 1.5” transmitter that magnetically attaches to the waistband. The small 3”x3”x3/4” battery-operated wireless receiver can be placed on a bedside table, dresser, or up to 50’ from child’s bed. A second receiver can be purchased to be placed in the parent's room.
Once urine is sensed, a loud sound comes from the receiver. Once this receiver is triggered by wetness, it continues to sound until the reset button is pushed. This helps ensure that you and your child wake up to the alarm, and your child gets out of bed to turn it off. A volume control dial on the receiver allows the user to control the level of sound. This bed wetting alarm also offers the choice of 8 random sounds or selecting one of 8 sounds to play each night.
When the alarm is not being used, the sensor clip should be detached from the wet fabric and the lever on the sensor should remain in the open position to prevent the transmitter and receiver from attempting to communicate with each other. Doing this regularly preserves battery life.
The advantage of this wireless bed wetting alarm is that it can be used with any of your child's own underwear. The sensor is placed on the outside of the briefs and detects the first few drops of moisture. Choosing the best location for the receiver is up to the family. This small battery operated unit can be placed as close as a bedside table or as far away as across the room. The alarm must be placed in a location where the child can hear it in order to learn the behavior of getting up independently to the alarm, and ultimately to a full bladder. It should be placed far enough from the bed, so the child cannot reach over and turn the receiver off without getting out of bed to do so. The second receiver for the parent's room is nice for situations where parents may not hear the alarm. Parental involvement is important initially, so that your child learns the proper response to this sound.
M012 - Transmitter with One Receiver
M012D - Transmitter with Two Receivers
|Receiver Warranty||1 Year|
|Transmitter/Sensor Warranty||3 Months|
|Sensor Type||Easy-clip sensor|
|Battery||Receiver- 2 x 1.5 volt AA alkaline or equivalent|
|Alarm Dimensions||Receiver-3" x 3" Transmitter- 1 x 12 volt A23|
|Sensor Dimensions||9.5 inches|
|Shipping Weight||10 ounces (View shipping rates and policies)|
|Instruction Manual||Malem Wireless Instruction Manual|
|Progress Chart||Malem Progress Chart|
|Troubleshooting Guide||Malem Troubleshooting/FAQs|
|Care Instructions||Clean sensor with soapy water and small toothbrush every few days to remove urine residue.|
|MANUFACTURER ITEM CODE||M012|
This product is ok but you have to be sure to open the clip up when not in use or you will go through a lot of batteries
Do not purchase this product. I repeat, do not purchase this alarm. If I could give it no stars I would. This is the hardest alarm to pair. It worked once and never worked again. I sent it back for them to fix, they then sent it back to me and it still did not work. The customer service rep was very honest and told me that this wireless alarm was not user friendly. They should stop selling this one all together.
We've been using this for two weeks. It had potential because when it works, it stops my child mid-release and we then get him up to finish in the bathroom. However, the alarm has failed 1/3 of the time - as in he wets completely and it doesn't go off.l at all. I've replaced batteries, re-paired the device, and we test it per the instructions every night before bed. It's difficult to break a habit when the alarm cannot be relied upon.
The primary unit works OK, but you pay extra for the parent remote and we can't get it to work reliably. The first night it didn't work at all. So the second night we paired it and tested it multiple times, it worked before bed. Then the battery died in the unit that clips to the underwear (if you don't put the clip in the open position when not in use, the unit drains the battery - there is no off switch for the clip unit). We changed the battery (it's a weird battery, so you won't have one at home. they send an extra, but we lost that so had to go buy more). Have not been able to get the parent unit to pair since then. There are directions but you have to push a button for which you need some tiny pin - but even then couldn't get it to work. Overall very disappointed in this product. And it was expensive. We bought a $30 one on amazon which doesn't have the parent unit, and it works just fine.
The wire that connects to the clip broke off while my son was sleeping. So we can't uevyge device any longer